Speck-electronics X.Sum Bedienungsanleitung PDF herunterladen (Seite 21)

Chapter 3 Operation Section 17

This modular plug connects the BB-03 Breakout Box to the multifunction I/O

connector [13] on the rear panel of the X.Sum.

These balanced ¼" TRS jacks are the left and right outputs of the Mix-B bus.

The signal present at these jacks is adjusted by the Monitor [7] control on the

front panel.

Another function of the breakout box connector will also let you connect your

own external preamps to the X.Sum should you want to experiment with a

more "colored" sound. The Mix-A (pre-fader) output jacks on the breakout

box bypass the output circuits and the master level control of the Xsum so you

can connect a pair of external preamps should you want to experiment with

"character" sounds.

The DC power cable that comes from the power supply connects to this 8 pin

circular connector. This connector and its respective plug is keyed so they will

only fit in one direction. For power supply installation instructions, refer to

the Interface & Setup Section in this manual.

The following connector illustration and chart as shown in figure 6 represents

the DC voltages to the 8 pin circular connector required to power the X.Sum.

PIN 1 0 VDC

PIN 2 0 VDC

PIN 3

+16.5 VDC

PIN 4 0 VDC

PIN 5

.5 VDC

PIN 6

PIN 7 0 VDC

PIN 8

Figure 6

16. Mix-A (pre fader)

Ouput Jacks

17. D.C. Power Inlet

15. Mix-B Output Jacks

.5 VDC

+16.5 VDC

14. Breakout Box

Connector

1 2 ... 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

Speck-electronics X.Sum Bedienungsanleitung Seite 21